![]() I bet there a lot of other subtle differences besides that. Due to the size of the action the top rail is quite a bit higher than normal. I should also add that even though certain rails might use the standard A2 "style" barrel nut, they are in now way the same as and AR15 free float. I'm not 100% but I think that Larue would use the AR-10 free float specific barrel nut wrench since it's one of the only freefloat designs for the AR-10 that uses a locking ring. Superior Weapons System E1 rails use a totally different type of nut and come with their own barrel nut wrench. A Geissele rail install is as easy as it gets. Removing a barrel nut is extremely easy though and opens up a lot more options. So I'm guessing that a standard AR15 barrel nut wrench would be all that's needed.ĭaniel defense Lite rails would use a nut that works with a spanner that is very similar to (if not the same) as a castle nut spanner. The Fortis REV II uses the standard GI barrel nut. Thus it's a specific barrel wrench for the Armalite AR10 Freefloat.įrom the Troy rails I've seen, they us the pre-existing "standard A2" type barrel nut and you just remove the delta ring assembly. These holes are what the AR10 freefloat barrel nut wrench interfaces with. Standard AR15 Barrel Nut For use with our C4 Handguards Connect With Us. Since the entire action is bigger, those holes are offset at a greater distance from the bore axis. SKU: STDBarrelNut Availability: Usually Ships in 1 to 2 Business Days Description. Since the freefloat has a barrel nut with a lock ring that retains the freefloat, there are holes in the barrel nut for the gas tube to pass through. Because of this the standard AR10 barrel nut uses a standard AR15 barrel nut wrench. Normally on an AR15 they also help support the gas tube. The C4 is where it is at as far as utilizing the standard barrel but. I wouldnt fiddle with any Troy kit, but thats just me. That said, of the available rails that are capable of attaching to the USGI barrel nut, id still choose the C4. Because of this, the notches that are in the barrel nut are used only for indexing with the barrel nut wrench and lining up the handguards. I love the profile of the RIS II and, as a close second, the DDM4 rail. The standard Armalite barrel nut is designed to use a delta ring assembly so that you can attach standard AR15 A2 handguards to it. When it comes to the wrench that is needed for an Armalite AR-10 Freefloat tube, you need to use a different wrench. When it comes to the thread on the AR10 receiver, they're both the same. I have an AR-10T and I have a standard AR10 that built from the ground up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |